Specifications
Housing Module
Built on fork pockets for easy installation. 4 swing open / lift
off doors for total access. All service items located on end
of housing for easy maintenance. Lube oil dip stick, lube oil
fill, lube oil drain, lube oil filter, fuel inlet, fuel outlet,
fuel filters, engine speed actuator, battery, air filter and
coolant recovery tank can be serviced from ground level. Control
and Output Modules plug into this housing. Requires only 66 inches
of space.
Remote Output Panel
Plugs into generator housing with flexible cable. Mounts to outside
of truck body. Contains output connectors, main and auxiliary
circuit breakers, convenience outlets and connection for engine
block heater. Made entirely of brushed stainless steel.
Remote Control Panel
Plugs into generator housing with flexible cable. Can be mounted
in various locations. Contains engine/generator controller, engine
speed controller, voltage regulator, 20A convenience outlet and
emergency breaker shut-off switch. Made entirely of brushed stainless
steel.
Engine
Cummins 4BT3.9-G4 turbocharged, after-cooled, 99 bhp, 4 cylinder
diesel. Meets EPA Mobile Off Highway, California CARB and SCAQMD
requirements. Equipped with filter for crankcase breather and
oversized air filter for clean operation in and out of the engine.
Frequency Control
Woodward digital electronic controller with actuator integrated
into fuel injection pump. No external linkage to maintain. Controller
mounted in remote control panel. Crystal accuracy for HMI lighting.
Controller
Engine control, AC monitoring, fault and pre-fault systems are
provided by a microprocessor-based system. All readouts are digital
and are listed below. Weather-proof glass cover. Mounted in remote
control panel.
|
Monitoring |
Faults and Pre-Faults |
|
AC Voltage - All Legs |
Oil Pressure Fault/Pre-Fault |
|
Amperage - All Legs |
Water Temp Fault/Pre-Fault |
|
Frequency - All Legs |
Over Crank Fault |
|
Oil Pressure |
Over Speed Fault |
|
Water Temperature |
Low Fuel Fault and Pre-Fault |
|
Battery Voltage |
Low Battery Pre-Fault |
|
Fuel Level |
Defective Oil Sending Unit Pre-Fault |
|
Time To Next Service |
Defective Water Sending Unit Pre-Fault |
Generator
Stamford/Newage UCI 224G. Low Wye (120/208) 75KW. Optional -
Hi Wye (277/480) 83KW. Optional, ZigZag (120/240) 62.5KW. 2/3
pitch windings avoid excessive neutral currents. Class H insulation.
CSA listed.
Voltage Regulator
SE 350 with voltage, stability and under frequency roll-off adjustments.
UL and CSA listed. Mounted in Remote Control Panel.
Circuit Breaker
250 amp breaker protects equipment in either single (if equipped)
or three phase. Weatherproof stainless steel cover. UL and CSA
listed. Mounted in remote output panel.
Electrical Connection
12 UL listed Cam-Lok type connectors as follows: 2 male ground,
2 female ground, 2 neutral, 2 leg one, 2 leg two and 2 leg three.
1 Edison 20 amp outlet and one Bates 100 amp provided for convenience
outlet. For Canada 60 amp Joy connector used. NEC approved panel
with CSA / UL components. Mounted in remote output panel.
|
Optional Accessories
Installation in Your Truck or Trailer Body
Requires a 48" side door, preferably on street side. Requires
bulkhead 66 inches back from front wall with small access door.
Requires installation of Remote Output Panel and Remote Control
Panel. Requires provision for air inlet from floor and air outlet
in roof. Can be performed at any truck body service center or
our location in Toronto. Instructions and engineered drawings
are available.
Electronic Service Kit
Provides total redundancy of all electronic parts. Each component
can be installed in less than ten minutes. Includes:
- Engine/Generator Controller Board Set
- Woodward Controller
- Voltage Regulator
- Voltage Adjust Pot
- Magnetic Pick-up
Single Phase Option
2 position switch with following voltages:
- 120 / 240 Single Phase (Zig Zag)
- 120 / 208 Three Phase (Lo Wye)
480 Volt Option
3 position switch with following voltages, includes current limiting.
- 120 / 240 Single Phase (Zig Zag)
- 120 / 208 Three Phase (Lo Wye)
- 277 / 480 Three Phase (Hi Wye) also used for 50 hz / 220 operation.
Size/Weight
Length: 85", Width: 36-1/2", Height: 68", Weight:
3400 pounds (1636 kg)
Fuel Consumption
| Load |
Gallons/Hour |
| 500A |
4.15 |
| 375A |
3.20 |
| 250A |
2.37 |
| 125A |
1.43 |
Noise Level
Less than 48 db(A) @ 50 feet when installed in truck body.
LitePOWER Insert Generator Benefits
- No need to purchase generator truck or trailer and tow vehicle
- No need to insure and license these vehicles
- No need to maintain these vehicles
- No need to park these vehicles on location and store them when not in use
|
LitePOWER Main Menu